TT 3.2 Valance
Here's a nice easy mod for around £25 pounds.
You can see here the location of 4 holes where there are 2
push-pin plastic connectors and 2 T25 Torx screws to undo.
You can also see the prong push clips that run along the upper edge
Undo the 2 Torx screws and push the centre pin of the 2 push pin connectors and remove them too.
Then lie on the floor,start at one end and put your hand up
and behind the valance,
begin to ease and push the retaining tabs and valance from behind.
Push the valance out of the
slotted grooves, its important to not bend it too much as it could split.
Fitting is the reversal of removal although the upper centre section may require some banging in with your hand a little harder than the other parts.